Epson TM-T70II / TM-T70 Thermal Paper Rolls 3 1/8 x 230 ft | BPA-Free American Made

Thermal Paper Rolls for the Epson TM-T70II and TM-T70 - 3 1/8 x 230 ft for the Front-Loading Under-Counter Printer

Thermal paper for the Epson TM-T70II goes in from the front, which is the whole reason the printer is tucked under a counter, a fuel desk or a teller window instead of taking up space on top. Every TM-T70 generation takes a 3 1/8 in (80mm) roll up to 83mm across, and these 3 1/8 in (80mm) x 230 ft rolls are 2.75 in (70mm) on a 1/2 in core: press the lever, drop the roll in, close the cover and it feeds clean and prints sharp.

No ink. No ribbon. No faded or half-printed receipts - a clean, dark image edge to edge on every ticket.

Key Features

• ✅ Fits the TM-T70, TM-T70-i, TM-T70II, TM-T70II-DT and TM-T70II-DT2, so older and newer stations share one stock
• ✅ Front-loading fit: change the roll without pulling the printer out from under the counter
• ✅ At 70mm across, the roll sits in the 83mm bay with room to spare and the cover shuts on the first try
• ✅ 230 ft on every roll, so a teller or cashier is not stopping to reload mid-line
• ✅ A colored stripe near the end of the roll tells staff to grab a spare before the next customer
• ✅ BPA-free coating, better for staff who tear and hand over receipts all shift
• ✅ Made in the United States, so every case you reorder matches the last one

Specifications

▶ Compatible Printers and Teller Devices

• Epson TM-T70 and TM-T70-i

• Epson TM-T70II (model M296A on the label), TM-T70II-DT and TM-T70II-DT2

• Epson TM-S2000 check scanner stations: receipts print on the paired TM-T70II.

• Gilbarco Passport fuel POS systems use the TM-T70II (Gilbarco part PA04270013).

Using a different Epson model? See our Epson Receipt Printer Paper Rolls page.

▶ How to Load Paper in a TM-T70II

1. Press the cover open lever to open the printer cover.
2. Take out the empty core.
3. Drop the new roll in so the paper feeds out from the bottom of the roll toward you.
4. Pull out some paper so it sits between the paper guides.
5. Close the cover and check the paper is still between the guides.
6. Tear off the extra.

Tip: a blank first ticket means the roll is facing the wrong way. Flip it and close the cover again.

▶ Roll Sizes That Fit a TM-T70II

✅ 3 1/8 in x 230 ft (this product) - a 70mm roll with 13mm to spare in the 83mm bay.

❌ Anything over 83mm (3.27 in) across - the roll will not seat and the cover stays open.

❌ Rolls with the paper glued to the core - Epson warns against them.

❌ Bond or carbonless rolls - the TM-T70 series prints on thermal paper only.

▶ How Many Rolls to Order

Figure on about 250 itemized receipts per roll, or around 450 when most tickets are short card slips.

• 6 rolls: one teller window or a quiet register.

• 12 or 18 rolls: one busy lane or fuel desk between orders.

• 24 rolls: two or three lanes.

• 50-roll case: the lowest cost per roll, for a branch or store running several stations.

▶ Fixing Blank or Faint Tickets

• Blank tickets: the coated side is facing the wrong way. Flip the roll.

• Faint or streaky print: the roll is not thermal stock, or it sat in heat before use. Swap in a roll from an unopened pack.

▶ Why American-Made Paper

The printer is a one-time purchase. The paper is the part you buy again and again, and it is the part that decides whether a lane keeps moving. Every roll here comes off a US line to one specification, so case ten runs exactly like case one.

▶ Storage

Heat turns thermal paper gray and sunlight fades it. Store spare cases sealed, off the floor of a warm back room and away from windows. At normal room temperature they keep printing dark for 5 years or more.